very important to check your pod "back travel" I like to start with 1.5mm and never more then 2.0mm... with car race ready with battery check ride height near LR corner of chassis by esc... Then lightly pull up on pod to fully extend the center shock... check with ride height gauge adjust length as needed... (more travel = more steering, more body roll) (less travel = less steering, less body roll)
post it up! im actually about to convert from all dubros to the new tc6 setup- wouldnt mind some tips on everything i am about to redo- servo starting angle, tie rod lengths, side shock oal, ect.
Last edited by horsedog; July 16th, 2014 at 02:02 PM.
very important to check your pod "back travel" I like to start with 1.5mm and never more then 2.0mm... with car race ready with battery check ride height near LR corner of chassis by esc... Then lightly pull up on pod to fully extend the center shock... check with ride height gauge adjust length as needed... (more travel = more steering, more body roll) (less travel = less steering, less body roll)
If travel is too much, 3mm, how do you reduce this number without giving up pod droop? Thank you
Shorten the shock shaft. Hold the shock shaft with needle nose pliers, gently not to scratch it, and turn the heim or ball cup, what ever you use on the shock shaft end.