|
-
January 10th, 2015, 08:18 AM
#1
Eliminating bump steer
Trying to run my servo flat. How is this done and still be able to get rid of bump steer ? Seems like no matter what I try , the right front toes in between 1 and 2 degrees when I compress the chassis. I have been able to eliminate it from the left but not the right. Any setup tips on how to stop bump steer with a flat mounted servo?
Thanks
RC
-
January 10th, 2015, 05:37 PM
#2
Administrator
What chassis are you running?
-
January 11th, 2015, 06:05 PM
#3
It's my own chassis using a KSG front end.
RC
-
January 11th, 2015, 10:56 PM
#4
Administrator
A flat servo is harder to get bumpsteer solved because it's hard to get a good angle on the right turnbuckle. It usually requires using lots of spacers underneath the ballcup/Dubro/TC6. Usually you want to get it to the point where the connector is about to touch the inside of the wheel. To test, draw a straight line on a peice of paper. Turn your wheels about 11 degrees, and line it up with the line on the paper. Look down from straight above and compress the suspension and see if the wheel moves. Each wheel needs to be solved independently .
-
January 12th, 2015, 09:39 AM
#5
Thank you for the reply James. Maybe I just haven't used enough spacing on the right side.
RC
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Copyright © 2014 McPappy.com. All rights reserved.
"McPappy Racing" name and logo are Registered Trademarks.
|
Product of Web Wonderland, Inc. Made in the USA
|
|
|
|